Research Article

Application of Superconducting Fault Current Limiter (SFCL) in Power Systems: A Review

Ignatius K. Okakwu
University of Benin, Nigeria
* Corresponding author
P. E. Orukpe
University of Benin, Nigeria
E. A. Ogujor
University of Benin, Nigeria
DOI icon 10.24018/ejeng.2018.3.7.799

Read Counter
2169

Downloads
1502

Citations

Share

Article Sidebar

Submitted 2018-06-21
Published 2018-07-19

Read counter = 2169 times

Table of Contents

Article Main Content

The fault current levels of an interconnected power network have witnessed a general rise due to increase in power demand. This rise in fault current if not properly mitigated may exceed the maximum ratings of the switchgear. Many conventional protective devices such as series reactors, fuses, high impedance transformers, etc. have high cost, increased power loss and loss of power system stability, which may ultimately cause lower reliability and reduced operational flexibility. Superconducting Fault Current Limiter (SFCL) is a flexible alternative to the use of conventional protective devices, due to its effective ways of reducing fault current within the first cycle of fault current, reduced weight and zero impedance during normal operation. This paper reviews various concepts of SFCLs and its applications in power systems.
Keywords: Fault Current Low Temperature Superconductor Power Systems Superconducting Fault Current Limiter

References

  1. H. Singh, and P. Jindal, “Enhancement of multi-machine stability using Fault Current Limiter and Thyristor Controlled Braking Resistor,” International Journal of Modern Computer Science, vol. 4, pp. 28-31, 2016.
     Google Scholar
  2. N. Zhou, J. Wu, and Q. Wang, “Three-phase Short-Circuit Current Calculation of Power Systems with High Penetration of VSC-Based renewable energy,” Journal of Energies, vol. 11, pp. 2-25, 2018.
     Google Scholar
  3. K. Makinde, F. O. Enemuoh, O. K. Lawal, I. Umar, B. Abubakar, and M. K. Mahmood, “Performance analysis of surge current protection using Superconductors,” European Scientific Journal, vol. 10, pp. 183-192, 2014.
     Google Scholar
  4. A. N. Rao, and P. R. Krishna, “The Fault level reduction in distribution system using an Active type SFCL,” International Journal of Engineering and Computer Science, vol. 5, pp. 17392-17396, 2016.
     Google Scholar
  5. M. C. Nagarathna, V. H. Murthy, and R. Shashikumar, “A Review on Super Conducting Fault Current Limiter (SFCL) in power system,” International Journal of Engineering Research and General Science, vol. 3, pp. 485-489, 2015.
     Google Scholar
  6. S. Yadar, G. K. Choudhary, and R. K. Mandal, “Review on fault current limiters,” International Journal of Engineering Research and Technology, vol. 3, pp. 1595-1603, 2014.
     Google Scholar
  7. B. V. Vaishnavi, S. R. S. Angelin, D. P. Trivenishree, N. Nidha, and G. J. Sowmya, “Superconducting fault current limiter and its application,” International Journal of Scientific and Engineering Research, vol. 7, pp. 126-134, 2016.
     Google Scholar
  8. A. Ramadan, “Permanent magnet fault current limiter for the power grid,” 9th International Conference on Sustainability in Energy and Buildings, ELSEVIER, pp. 768-775, 2017.
     Google Scholar
  9. M. S. Alam, M. A. Y. Abido, and I. El-Amin, “Fault current limiters in power systems: A Comprehensive Review,” Journal of Energies, vol. 11, pp. 2-24, 2018.
     Google Scholar
  10. X. Zhang, H. S. Ruiz, J. Geng, and T. A. Coombs, “Optimal location and minimum number of superconducting fault current limiters for the protection of power grids,” International Journal of Electrical Power and Energy Systems, vol. 87, pp. 136-143, 2017.
     Google Scholar
  11. H. Yaghoubi, “The most important magnetic levitation applications,” Journal of Engineering, vol. 2013, pp. 1-19, 2013.
     Google Scholar
  12. M. Pannerselvan, P. Prakasam, and J. K. Chithra, “Implementation of an effective fault current limiter for 1.51MW DFIG in wing power systems,” International Journal of Engineering and Technology, vol. 6, pp. 627-635, 2014.
     Google Scholar
  13. Y. Zhao, “Investigation of the Superconducting Fault current limiter applied in Electrical power system with Distributed Generations (DGs),” The University of Queensland, Australia, PhD Thesis, pp. 41-57, 2016.
     Google Scholar
  14. T. Uchihashi, “Two-dimensional Superconductors with atomic-scale thickness,” Superconductor Science and Technology, vol. 30, pp. 1-38, 2016.
     Google Scholar
  15. T. Nishihara, T. Hoshino, and M. Tomita, “Analysis of FCL effect caused by superconducting DC Cables for railway system,” IOP Conference Series: Materials Science and Engineering, pp. 1-9, 2017.
     Google Scholar
  16. A. N. Aswathi, and K. T. Krishna, “Microgrid protection using superconducting fault current limiter,” International Research Journal of Engineering and Technology, vol. 3, pp. 1320-1325, 2016.
     Google Scholar
  17. T. B. Wescley, “Thermal-Electrical Analogy for simulations of superconducting fault current limiters,” Journal of Cryogenics, vol. 62, pp. 97-109, 2014.
     Google Scholar
  18. C. Song, L. Peng, B. Roy, P. Jean-Francois, and L. Brad, “Analysis of a Switched Impedance transformer-type Non-Superconducting Fault Current Limiter,” IEEE Transactions on Power Electronics, vol. 30, pp. 1925-1936, 2014.
     Google Scholar
  19. S. Yadav, G. K. Choudhary, and R. K. Mandal, “Review on fault current limiters,” International Journal of Engineering Research and Technology, vol. 3, pp. 1595-1603, 2014.
     Google Scholar
  20. J. Pradhan, U. Bhunia, M. Ahammad, A. Roy, S. K. Thakur, C. Mallik, and S. Saha, “Design, fabrication and testing of HTS based current lead,” Indian Journal of Cryogenics, vol. 36, pp. 1-3, 2011.
     Google Scholar
  21. A. Etxegarai, I. Zamora, G. Buigues, V. Valverde, E. Torres, and P. Eguia, “Models for fault current limiters based on superconductor materials,” International Conference on Renewable Energies and Power Quality, Madrid, Spain, pp. 284-289, 2016.
     Google Scholar
  22. J. A. Demko, and R. C. Duckworth, “Cooling Configuration design considerations for long-length HTS cables,” IEEE Transactions on Applied Superconductivity, vol. 19, pp. 1-5, 2009.
     Google Scholar
  23. B. Zhiming, M. Chi, C. Chuan, and P. Yuchun, “Study on the Excitation of a Bi-2223 small superconducting coil by a Pulse-Type Magnetic Flux Pump,” IEEE Transactions on Applied Superconductivity, vol. 27, pp. 1-5, 2017.
     Google Scholar
  24. S. Kanungo, “Synthesis and Characterization of Gd doped BSCCO-2212,” MSc Thesis, Department of Physics, National Institute of Technology, Rourkela, India, pp. 14-23, 2013.
     Google Scholar
  25. S. H. Lim, H. S. Choi, D. C. Chung, Y. H. Jeong, Y. H. Han, and B. S. Han, “Fault Current Limiter Characteristics of Resistive-Type SFCL using a Transformer,” IEEE Transactions on Applied Superconductivity, vol. 15, pp. 2055-2058, 2005.
     Google Scholar
  26. P. V. Rama, and M. Swathi, “Superconducting Fault Current Limiter in DC Systems with MLI Fed to IM,” ITSI Transactions on Electrical and Electronics Engineering, vol. 3, pp. 25-28, 2015.
     Google Scholar
  27. M. Priyanka, and P. J. Shah, “Designing and Analysis of Power System with SFCL Module,” International Journal on Recent and Innovation Trends in Computing and Communication, vol. 3, pp. 78-82, 2015.
     Google Scholar
  28. G. Didier, C. H. Bonnard, T. Lubin, and J. Levegne, “Comparison between inductive and resistive SFCL in terms of current limitation and power system transient stability,” Electric Power System Research, vol. 125, pp. 150-158, 2015.
     Google Scholar
  29. C. V. Chaudhary, G. K. Mahajan, and A. P. Chaudhary, “A Comprehensive review on Superconducting fault current limiters in Electrical Utility Network,” International Journal of Emerging Trends in Science and Technology, vol. 2, pp. 2466-2479, 2015.
     Google Scholar
  30. R. Pawar, and P. Chavan, “Minimizing of Fault Current using SFCL technology,” International Journal of Engineering Development and Research, vol. 5, pp. 1261-1267, 2017.
     Google Scholar
  31. Q. Yang, S. L. Blond, F. Liang, M. Zhang, W. Yuan, and J. Li, “Design and application of Superconducting Fault Current Limiter in a Multi-Terminal HVDC System,” IEEE Transactions on Applied Superconductivity, vol. 27, pp. 1-5, 2017.
     Google Scholar
  32. R. K. Rojin, “A Review of Power quality problems and solutions in Electrical Power System,” International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering, vol. 2, pp. 5605-5614, 2013.
     Google Scholar
  33. P. Mahajan, P. J. Shah, and R. Saxena, “Analysis of smart grid with superconducting fault current limiters,” International Journal of Science, Spirituality, Business and Technology, vol. 3, pp. 87-91, 2015.
     Google Scholar
  34. S. M. Blair, C. D. Booth, and G. M. Burt, “Current-time characteristics of resistive superconducting fault current limiters,” IEEE Transactions on Applied Superconductivity, vol. 22, pp. 5600205-5600205, 2012.
     Google Scholar
  35. A. Mohamed, and A. M. Emad, “Enhancement of Multi-Machine power system Transient stability using superconducting fault current limiters with YBCO and Bi-2212,” World Congress on Power and Energy Engineering, Cairo, Egypt, 2012.
     Google Scholar
  36. M. A. Mohamed, and A. M. Emad, “Enhancement of Multi-Machine Power System Transient Stability using Superconducting Fault Current Limiters with YBCO and Bi-2212,” International Journal on Power Engineering and Energy, vol. 5, pp. 418-423, 2014.
     Google Scholar
  37. F. Tariverdi, and A. Doroudi, “Selection of Resistive and Inductive Superconductor Fault Current Limiters location considering system transient stability,” Journal of Electric power and Energy Conversion Systems, vol. 1, pp. 72-78, 2016.
     Google Scholar
  38. K. Masoud, and B. Mehdi, “Transient Stability Improvement of Power Systems by optimal sizing and allocation of Resistive Superconducting Fault Current Limiters using Particle Swarm Optimization,” Advanced Energy: An International Journal (AEIJ), vol. 1: pp. 11-27, 2014.
     Google Scholar
  39. I. K. Okakwu, and E. A. Ogujor, “Enhancement of transient stability of the Nigeria 330kV transmission network using Fault Current Limiter,” Journal of Power and Energy Engineering, vol. 5, pp. 92-103, 2017.
     Google Scholar
  40. S. L. Jerika, A. B. Carlos, Y. S. Carlos, A. Silhanek, and V. Moshchalkov, “Electrical and Magnetic Characterization of BSCCO and YBCO HTS Tapes for Fault Current Limiter application,” IEEE transactions on Applied Superconductivity, vol. 21, pp. 3398-3402, 2011.
     Google Scholar
  41. H. Raza, S. Muhammad, and B. Syed, “Protection and Coordination using Superconducting Fault Current Limiters in Micro-grids,” Journal of the Korean Institute of Illuminating and Electrical Installation Engineers, vol. 10, pp. 26-36, 2017.
     Google Scholar
  42. M. Panneerselvan, P. Prakasan, and J. K. Chithra, “Implementation of an Effective Fault Current Limiter for 1.5mw DFIG in Wind Power System,” International Journal of Engineering and Technology, vol. 6, pp. 627-635, 2014.
     Google Scholar
  43. A. Biswas, M. E. Khan, and U. Sarker, “Transient Stability Improvement of a Conventional Power System by Superconducting Fault Current Limiter,” Global Journal of Researches in Engineering, vol. 13, pp. 1-6, 2013.
     Google Scholar
  44. H. Hooshyar, H. Heydari, M. Savaghebi, and R. Sharifi, “Resistor type Superconducting Fault Current Limiter: Optimum Shunt resistance determination to enhance power system transient stability,” IEEJ Transactions on Power and Energy vol. 2, pp. 299-308, 2009.
     Google Scholar
  45. B. C. Sung, and J. Park, “A Study on Optimization of Resistive SFCL for Multi-Machine Power System using Eigenvalue Analysis,” Journal of International Council on Electrical Engineering, vol. 4, pp. 167-172, 2014.
     Google Scholar